Atom feed of this document
  
Draft -  Draft -  Draft -  Draft -  Draft -  Draft -  Draft -  Draft - 

 L3 metering agent

You can run an L3 metering agent that enables layer 3 traffic metering. In general, you should launch the metering agent on all nodes that run the L3 agent:

neutron-metering-agent --config-file NEUTRON_CONFIG_FILE --config-file L3_METERING_CONFIG_FILE

You must configure a driver that matches the plug-in that runs on the service. The driver adds metering to the routing interface.

Table 7.4. Settings
Option Value
Open vSwitch
interface_driver ($NEUTRON_CONF_DIR/metering_agent.ini) neutron.agent.linux.interface.OVSInterfaceDriver
Linux Bridge
interface_driver ($NEUTRON_CONF_DIR/metering_agent.ini) neutron.agent.linux.interface.BridgeInterfaceDriver
Questions? Discuss on ask.openstack.org
Found an error? Report a bug against this page

loading table of contents...