Atom feed of this document
  
Draft -  Draft -  Draft -  Draft -  Draft -  Draft -  Draft -  Draft - 
 Configuration

This example uses VLAN isolation on the switches to isolate tenant networks. This configuration labels the physical network associated with the public network as physnet1, and the physical network associated with the data network as physnet2, which leads to the following configuration options in linuxbridge_conf.ini:

[vlans]
tenant_network_type = vlan
network_vlan_ranges = physnet1,physnet2:100:110

[linux_bridge]
physical_interface_mappings = physnet2:eth1
[Note]Note

In this configuration there isn't a bridge mapping for physnet1 as it is only needed on the network host, which maps it to the Open vSwitch bridge br-ex connected to the external network as seen below.

Questions? Discuss on ask.openstack.org
Found an error? Report a bug against this page

loading table of contents...